PocketWizard AC3 ZONE CONTROLLER-CANON
When you add the Pocket Wizard AC3 ZoneController for Canon to your on-camera MiniTT1 Transmitter or FlexTT5 Transceiver, you instantly have three zones of flash control. Whether in E-TTL II or Manual mode, you have control over all your flashes from your camera position. Put your flashes wherever you want, without worrying about having to access them during a shoot. Three clearly labeled dials let you increase or decrease power to three zones of flash in 1/3-stop increments--with a range of up to six stops. Three switches allow you to change zones between Manual, Auto (PowerTracking/E-TTL II) or OFF. Best of all, the design is simple to use, with an intuitive interface.
The AC3 requires firmware version 5.10 (or later) be installed on paired MiniTT1's and FlexTT5's.
Three independent zones of flash control
6 stops of flash control in 1/3rd stop increments
Works in PowerTracking/E-TTL II or Manual mode
Turn zones on and off remotely
Put your flashes where you want, without worrying about accessing them during a shoot
- Mounting Hot shoe
- Status Indicator LED: Green status indicator
- Operating Temperature Above 5øF (-15øC) and below 120øF (50øC)
- Storage Temperature Above 22øF (-30øC) and below 185øF (85øC)
- Power Receives power from MiniTT1 Transmitter or FlexTT5 Pocket Wizard
- Dimensions 2 x 1.7 x 0.9" (5 x 4.2 x 2.1 cm)
- Weight 0.82 oz (23.25 g)
- Requirements MiniTT1 Transmitter or FlexTT5 Transceiver with firmware version 5.10 (or later) needed as a host
Compare to other products in the Slaves,Triggers and Cables range.
Compare to other products in the PocketWizard range.
